Lazy people do it yourself! Easy to get refrigerator noise problems

There are many lazy people who will not take care of themselves and will not take care of the family. The household appliances will often bring them a lot of trouble, but they are more lazy to find someone to repair!嗨 这样 这样 这样 这样 这样 这样 这样 这样 这样 这样 这样 这样 这样 这样 这样 这样 这样 这样 这样 这样 这样 这样 这样 这样! Hurry up, don't look lazy!

Method one, the back and the wall into a certain degree of inclination so that the back of the refrigerator and the wall into a certain angle of inclination, the back and wall angle, the refrigerator side of the opening, one side of the opening is small, showing a trumpet. The loud noise emitted from one side should be facing the object; the noise from the small side should be less, and the area of ​​activity should be faced.

Method two, the pipeline and the box body should be reinforced firmly check to adjust whether the connection between the outer pipe and the box body is loose, so as to avoid resonance when the compressor works. Therefore, the outer pipe must be fixed, bolts should be added with spring washers to prevent loosening.

Method 3: Compressor base should be firm If the compressor is pressed tightly by hand, the noise will be obviously reduced and the noise raised by the hand will be increased. Generally, the compressor is fixed on the base of the compressor, the uneven force or bolt looseness, and the compressor is loose. Insufficient base plate, should adjust, tighten the bolts and replace the loss of elastic gasket.

Method 4: Use rubber blocks to suppress vibration of the tube If the refrigerator is in use, such as noise, it is advisable to use a waste bicycle tire, cut it into a circular shape with a diameter of 30 mm, and cut out a round hole with a diameter of about 5 mm from the outside to the outside. Cut the center so that the rubber piece can be attached to the tube. When the refrigerator compressor is running, touch the tube by hand. Any tube with a sensation of jitter can be put on several rubber blocks. A refrigerator needs 10 to 20 sets, and the noise will drop immediately. This is because the rubber block suppresses the "resonance" of the tube vibration.

Method 5, properly raise the four corners of the refrigerator, increase the refrigerator up to 3 to 6 cm and adjust the balance of the four corners so that the air convection space at the bottom of the box increases. In this way, noise from the compressor and other noises from the bottom come out from the bottom of the box, reducing the noise coming from both sides and the upper part of the refrigerator.