Millet box mini remote control failure, what should I do? Recently children's shoes often consult this question. Let Xiao Bian tell you the solution.
Solution:
1. If the remote control battery has electricity, please replace the battery in time.
2, if the battery power is sufficient, then check the battery slot, because the millet box mini version of the remote control's positive contact is a flexible metal wire, if its area of ​​contact with the battery is too small, and the fixed instability, it will Causes the battery to be in loose contact with the remote control and cannot supply power normally.
3, or, when the battery is installed, the battery cathode cannot be tightly fitted with the back cover after the back cover is closed. In use, the battery shake causes poor contact. If you encounter the above two conditions, you can try to insert a thick piece of paper or add a sponge or the like on the positive electrode of the battery.
4, remote control distance is too large, the general remote control remote control range of about 10 meters, to maintain no obstacles between the remote control and the TV receiver.
Remote control maintenance method:
1, the purchase of regular batteries, poor quality batteries not only damage the life of the remote control, but also dangerous to the human body.
2. Replace the batteries of the remote controller in pairs. Do not mix old and new televisions or different types of batteries to prevent explosion.
3, please keep the battery compartment dry. Excessive moisture can cause short circuit and component damage.
4, when using the remote control should avoid strong light, high temperature, or will affect the use of remote control.
5, in the case of not using for a long time, please remove the battery to prevent electricity and battery leakage.
6. When the remote control casing (outside surface) is dirty, please do not use organic detergent such as natual water, gasoline, etc. to prevent the casing of the remote control from being corroded.
7. If you need to clean the inside of the remote control, please carefully disassemble the conductive rubber and the key surface of the circuit board, use a proper amount of anhydrous alcohol to clean it, and use the hair dryer to dry it.