Energy-Saving Motion-Sensor UFO LED High Bay Light for Industrial Light

Energy-saving Motion-Sensor UFO LED High Bay Light for Industrial Light






Parameter
Features

1.IP65 both for indoor and wet location
2.Various beam angleoptions:60degree,90degree,120degree
3.3030 led chip,140lm/w max
4.Intelligent microwave sensor,auto ON or OFF LED high bay
5.From 100w to 200w solution for 6 to 20 meters
6.Meamwell driver,1-10V and PWM or resistance dimmable available
7.5 years warranty

Installation instructions


1. Fixtures must be operated by a licensed electrician.
2. Check if fixtures are sloid and in good condition once packaging is open.
3. Do not let fixture fall down from ceiling system or clash to hard stuff.
4. Make sure that the cable of fixture is long enough to connect. Do not knot or pull the cable strongly while  wiring.
5. Do connect input end of fixture to output end of LED driver.
6. Wiring must be firm and tight with insulation protection well. Be aware of electricity shock.
7. Keep fixture and LED driver away from water or liquid, free from electric leakage and electricity shock.
8. Must use LED driver approved by Lumin, otherwise, fixtures may not work normally, and may be damaged, may cause unexpected incidents. Lumin will not bear any responsibilities due to such deeds.  

Application





Wide beam angle with good lighting distribution is quite suitable for industrial lighting,warehouse,factory,gym,etc.

Do's & Don't's
 
1. It's only used indoors.
2. Check if fixtures are in good condition before using.
3. Keep packing material away from children, and prevent children from playing.  
4. Keep necessary accessories away from swallowing by Children.
5. Do not stare at light source directly for a long time.
6. Please don't cover anything on the fixture.
7. Do not disassemble or repair fixtures by unlicensed people. Otherwise, Lumin has the right to refuse replacement or maintenance.
8. Must switch off electricity before cleaning. Do clean fixtures with dry soft cloth, free from chemical or corrosive matters. 


Trouble Shooting
 
Environmentally friendly
  (1) No glare, mercury, ultraviolet, infrared or other hazardous substances
  (2) Operating Temperature: -25ºC to 55ºC
  (3) Operating Humidity: 10% to 80%
  (4) Storage Temperature: -40 to +85 ºC
  (5) Storage Humidity: 10% to 80%

Benifits

1.Replacing CFL tube fixture of 2*2 (62x62cm), saving 70% energy
2.The joint gap is tiny and there is no light link.
3.The light distribution is uniform,without bright border.
4.The back plate is lighter weight and better heat dissipation.
5.LED driver adopt double screen input and output line,with CE certification,with famous LED driver.

Our company profile






  Based in Shenzhen, Lumin Lighting is a fast-growing semiconductor lighting manufacturer
  and supplier  in China. Lumin Lighting was founed on November 17, 2008. Since its
  founding, Lumin Lighting is committed to developing, manufacturing,and popularizing LED
  lighting products, responding to the government policy of energy-saving, emission reduction,
  and maintainable development. Nowadays, Lumin Lighting has already been successful in
  providing quality LED lighting products and green lighting solutions to thousands of families,
  institutions, and communities worldwide.

  Lumin Lighting  product lines mainly include LED panel light, LED tube light, LED
  downlight, LED  bulbs, LED strip, and LED street light, LED flood light, LED garden light,
  and LED underground light. Meantime, Lumin Lighting also provides customized lighting
  solutions to customers. 


  Lumin Lighting takes product quality as our lifeline. We focus on quality control during the
  whole  production process by seriously carrying out ISO 9001 Quality System and ISO
  Environment Management System. At the same time, we emphasize training of skills and
  capabilities of our workers and staff to improve production management.  The products
  manufactured have already been awarded with certificates of CE, RoHS, and UL by
  authoritative organizations. With good quaity control, our products are well received by
  customers throughout the world.

  Lumin Lighting  has an excellent research and development team. New products are
  launched  and old ones are refined every year. At present, Lumin has been recognized as
  a leading LED lighting brand in the global market. Our products have been exported to
  over 30 countries and regions in the world such as Spain, France, Italy, Japan, and India,
  establishing close business relaton with local distributors, lighting consultants, building
  contractors as well as end users.  

  Facing severe global warming and energy crisis, Lumin Lighting would like to work with
  anyone who loves the earth an  environment protection in order to make a better place for the
  human being, by utilizing and popularizing our green LED lighting products. 

Best service
1.Your inquiry will be replied within 24 hours
2.Customized specificaton can be accepted
3.Protection of your sales area,ideas of design and all your private information
4.Best-trained and experienced sales follow up with your inquiries and orders

FAQ
Q1.Can I have a sample order for LED light?
A:Yes.We welcome sample order to test and check quanlity.Mixed samples are acceptable.
Q2.What about the lead time?
A:Sample needs 3-5days,mass production time needs 1-2 weeks for order quantity more than.
Q3.Do you have any MOQ limit for LED light order?
A:Low MOQ 1pc for sample checking is avaiable.
Q4.How do you ship the goods and how long does it take to arrive?
A:We usually ship by DHL,FedEx or TNT.It usually takes 3-5 days to arrive.Airline and sea shipping also optional.
Q5:Is it ok to print my LOGO on LED light product?
A:Yes.Please inform us formally before our production and confirm the design firstly based on our samle.
Q6.Do you offer guarantee for the products?
A:Yes.We offer 2-5 years warranty to our producs.
 
If you want to well know more informations,pls do not hesitate to contact us. Energy-saving Motion-Sensor UFO LED High Bay Light for Industrial Light






Parameter
Features

1.IP65 both for indoor and wet location
2.Various beam angleoptions:60degree,90degree,120degree
3.3030 led chip,140lm/w max
4.Intelligent microwave sensor,auto ON or OFF LED high bay
5.From 100w to 200w solution for 6 to 20 meters
6.Meamwell driver,1-10V and PWM or resistance dimmable available
7.5 years warranty

Installation instructions


1. Fixtures must be operated by a licensed electrician.
2. Check if fixtures are sloid and in good condition once packaging is open.
3. Do not let fixture fall down from ceiling system or clash to hard stuff.
4. Make sure that the cable of fixture is long enough to connect. Do not knot or pull the cable strongly while  wiring.
5. Do connect input end of fixture to output end of LED driver.
6. Wiring must be firm and tight with insulation protection well. Be aware of electricity shock.
7. Keep fixture and LED driver away from water or liquid, free from electric leakage and electricity shock.
8. Must use LED driver approved by Lumin, otherwise, fixtures may not work normally, and may be damaged, may cause unexpected incidents. Lumin will not bear any responsibilities due to such deeds.  

Application





Wide beam angle with good lighting distribution is quite suitable for industrial lighting,warehouse,factory,gym,etc.

Do's & Don't's
 
1. It's only used indoors.
2. Check if fixtures are in good condition before using.
3. Keep packing material away from children, and prevent children from playing.  
4. Keep necessary accessories away from swallowing by Children.
5. Do not stare at light source directly for a long time.
6. Please don't cover anything on the fixture.
7. Do not disassemble or repair fixtures by unlicensed people. Otherwise, Lumin has the right to refuse replacement or maintenance.
8. Must switch off electricity before cleaning. Do clean fixtures with dry soft cloth, free from chemical or corrosive matters. 


Trouble Shooting
 
Environmentally friendly
  (1) No glare, mercury, ultraviolet, infrared or other hazardous substances
  (2) Operating Temperature: -25ºC to 55ºC
  (3) Operating Humidity: 10% to 80%
  (4) Storage Temperature: -40 to +85 ºC
  (5) Storage Humidity: 10% to 80%

Benifits

1.Replacing CFL tube fixture of 2*2 (62x62cm), saving 70% energy
2.The joint gap is tiny and there is no light link.
3.The light distribution is uniform,without bright border.
4.The back plate is lighter weight and better heat dissipation.
5.LED driver adopt double screen input and output line,with CE certification,with famous LED driver.

Our company profile






  Based in Shenzhen, Lumin Lighting is a fast-growing semiconductor lighting manufacturer
  and supplier  in China. Lumin Lighting was founed on November 17, 2008. Since its
  founding, Lumin Lighting is committed to developing, manufacturing,and popularizing LED
  lighting products, responding to the government policy of energy-saving, emission reduction,
  and maintainable development. Nowadays, Lumin Lighting has already been successful in
  providing quality LED lighting products and green lighting solutions to thousands of families,
  institutions, and communities worldwide.

  Lumin Lighting  product lines mainly include LED panel light, LED tube light, LED
  downlight, LED  bulbs, LED strip, and LED street light, LED flood light, LED garden light,
  and LED underground light. Meantime, Lumin Lighting also provides customized lighting
  solutions to customers. 


  Lumin Lighting takes product quality as our lifeline. We focus on quality control during the
  whole  production process by seriously carrying out ISO 9001 Quality System and ISO
  Environment Management System. At the same time, we emphasize training of skills and
  capabilities of our workers and staff to improve production management.  The products
  manufactured have already been awarded with certificates of CE, RoHS, and UL by
  authoritative organizations. With good quaity control, our products are well received by
  customers throughout the world.

  Lumin Lighting  has an excellent research and development team. New products are
  launched  and old ones are refined every year. At present, Lumin has been recognized as
  a leading LED lighting brand in the global market. Our products have been exported to
  over 30 countries and regions in the world such as Spain, France, Italy, Japan, and India,
  establishing close business relaton with local distributors, lighting consultants, building
  contractors as well as end users.  

  Facing severe global warming and energy crisis, Lumin Lighting would like to work with
  anyone who loves the earth an  environment protection in order to make a better place for the
  human being, by utilizing and popularizing our green LED lighting products. 

Best service
1.Your inquiry will be replied within 24 hours
2.Customized specificaton can be accepted
3.Protection of your sales area,ideas of design and all your private information
4.Best-trained and experienced sales follow up with your inquiries and orders

FAQ
Q1.Can I have a sample order for LED light?
A:Yes.We welcome sample order to test and check quanlity.Mixed samples are acceptable.
Q2.What about the lead time?
A:Sample needs 3-5days,mass production time needs 1-2 weeks for order quantity more than.
Q3.Do you have any MOQ limit for LED light order?
A:Low MOQ 1pc for sample checking is avaiable.
Q4.How do you ship the goods and how long does it take to arrive?
A:We usually ship by DHL,FedEx or TNT.It usually takes 3-5 days to arrive.Airline and sea shipping also optional.
Q5:Is it ok to print my LOGO on LED light product?
A:Yes.Please inform us formally before our production and confirm the design firstly based on our samle.
Q6.Do you offer guarantee for the products?
A:Yes.We offer 2-5 years warranty to our producs.
 
If you want to well know more informations,pls do not hesitate to contact us.

Patch Panel

Patch Panel,48 ports patch panel,half U patch panel,patch panel 24 port

NINGBO UONICORE ELECTRONICS CO., LTD , https://www.uniconmelectronics.com