iPhone/iPad users are complaining that their machines have become slower

Do you think the iPhone is getting slower and slower, and often not even charging electricity? This is not your illusion. On Apple’s official forum, up to dozens of pages of discussions from around the world, these iPhone/iPad users are complaining about their own The machine becomes slower to charge, whether it's using a charger, connecting to a computer or plugging it into a car.

This is not Apple's own software or hardware problem, and the reason for this is surprisingly simple. It is that the Lightning charging hole is likely to be blocked by something foreign, such as cotton, dust and so on. As time goes by, it will inevitably cause dirt in the environment, or small cotton wool in the pocket, etc. The Lightning charging hole will add a layer of gray, which will slow the charging speed.

To fix this problem is very simple. Just close the iPhone or iPad, take a toothpick or paper clip, and carefully reach into the Lightning connector, and check out the batt or thread. You will be surprised to find that there are so many dirt hidden in the Lightning hole: If you feel that there is no improvement, or if you don't find any dirt at all, CNET recommends that you use air spray guns and other things to keep the dirt inside. Spurt out. Or try another one.

Of course, power consumption/slow charging may also be a problem with software settings.

Have you ever tried to charge the iPhone to the Lightning line, but it seems to have no response. Then you try to move the Lightning line slightly and finally find a very specific angle to charge. Unfortunately, as long as it touches the iPhone a little, charging will be interrupted. Your first thought may be that the Lightning line is broken, but in fact the problem may be much simpler than you think.

Whether you put your iPhone in your pocket or bag on weekdays, there will always be dust and debris coming into the Lightning socket. Over time, these debris can plug the Lightning connector and cause poor contact. Looking into the jack from the outside may not seem like debris, but you can insert a 4K clip or a SIM card with the iPhone pin into the Lightning slot, and gently around it. Then you will come up with unexpectedly large amounts of debris.

After cleaning, try to connect the Lightning line and you will find that you can charge immediately, even if you shake the Lightning line, it will not interrupt the charge. If this method is still invalid, consider changing the line.

With the rapid development of science and technology, smart phones have become more and more widely used in life. The number of iPhone holders has started to increase. However, various problems have arisen. In addition to the data line interface, it is prone to break. Apart from the phenomenon, the most obvious is that when the mobile phone is charged, it often shows no response, or the charging suddenly becomes very slow, but it can be used normally after re-plugging and adjusting the position.

Apple Data Line

Why is it causing these problems? There are several reasons: the first data line is broken, the solution: find a clean piece of cotton on the top to a bit of alcohol or high spirits and then wipe the data line above, pay attention to observe whether the data line above the joint of copper rust, if there is copper rust Repeatedly rub several times more, or use other metals (harder than copper) to remove the copper rust. This can only be used temporarily for a short period of time. In this case, the data cable must be changed to avoid problems with the data cable and burn out the phone.

Apple adapter

The second reason: There is foreign matter in the mobile Lighting interface, or the usage time is too long. There is too much dust in the interface, and the charging interface is blocked, resulting in poor contact during charging. The solution is to prepare the card pin, thin cotton cloth, alcohol, find a better light, the first step is to turn off the phone first, the second step to the mobile phone interface to the light side, the package can see the interface The situation inside. The third step is to use the pin to pick out the foreign matter and accumulated dust inside the interface. Be careful not to use too much force, and then observe whether there are foreign objects or dust in the interface. If you can not use the data line to try whether it can be charged normally, if there is no dust or foreign matter inside, you can use the card pin top of the cotton cloth with added alcohol (not to mention too much alcohol, cotton wet touch a little on it) Wipe the interface inside , rub several times back and forth. After completing the above method, the phone is allowed to stand for 15 minutes, until the alcohol is completely dry, at boot.

Apple Data Line

The third reason: The charger used does not match the Apple mobile phone. Solution: Change the charger.

Coffee Grinders

SHENZHEN CHONDEKUAI TECHNOLOGY CO.LTD , https://www.szsiheyi.com